You should be able to SSH to from the attached computer.Įdit: Ricardo's answer reminded me that you could also just do step 1 then see my answer on this related post. When you put the SD card in the Pi and plug it in to your computer (use the left USB port where the USB connectors are on the bottom), it should show up as an ethernet device. Don't add it on a new line, add it on the same line. Give the Pi plenty of time to boot up (it can take as much as 90 seconds - or more) Step 7. Pi Zero W: Plug a micro-USB power supply cable into the power port.

Raspberry Pi 4: Plug a USB-C power supply cable into the power port. Edit the file cmdline.txt and add modules-load=dwc2,g_ether right after it says rootwait. Remove the mini-SD card from the adapter and plug it into the Raspberry Pi.Edit the file config.txt and add dtoverlay=dwc2 on its own line at the end.That one will work.) Now the Pi will enable SSH on boot. (If you're running Windows, only one drive will show up. First, the Raspberry Pi Foundation disabled SSH as a security precaution, so you'll have to connect the SD card to a computer and put a file called 'ssh' (no extension) in the drive labeled 'boot' that pops up.Doing this with a NOOBS SD card is a little harder and (to my knowledge) impossible on Windows. You can SSH in from USB after some configuration.

Raspberry pi zero headless setup wifi